- Helps to prevent motor axle (shaft) rotation within the drop-out.
- Front or Rear Motors.
- Our “K” design allows for Straight or Curved Fork Application.
- Ours are Laser Cut in the USA.
- Stainless Steel.
- Includes one Hose Clamp.
No it does not matter, the torque arm plates are sized to accomodate a 14mm axle, but will fit a 12mm fine as well. With a 12mm axle, there is a small gap at the top or bottom of the slotted hole, but it is of no consequence and does not affect the spinout retention strength.
A 14mm axle has a much wider flat area and provides more spinout protection, both inside a dropout but especially inside a torque plate. However, a 14mm axle on front forks often leads to interference issues with the large diameter 14mm nut and washers, and it’s a bad situation if the washers and nut don’t stack up flat against the dropout.